Step execution resulted in an EndJob command

I load up a DTS for the first time and hit test job, whilst none of my steps tell the system to run an EndJob, I get " Step execution resulted in an EndJob command" shown before the test pane comes up and shows #ERROR for all target results.

If I refresh, everything comes through fine.. conversely if I close down the test job and re-run it, it is fine again. If I close the DTS and re-open it, once again I get the error on the first run.

Obviously this error means that it's automation in the console fails.

Any thoughts on what could be causing this?

Posted by Chris C. on Jul 3 2009 8:02AM { U583 , F8 , T696 , C1798 }

(1) Answer

Login